When choosing a new pool heat exchanger, you need to consider your budget, the type of water in your pool, and your mechanical know-how. It’s best to consult a technician if you’re unsure of what you’re looking for. There are many options available, so it’s important to do your research before making a final decision. Listed below are some factors to consider when choosing the right pool heat exchanger for your needs.
Consider investing in low emission heaters:
If you’re trying to save money while maintaining your pool, you may consider investing in a low emission pool heater. These units are more environmentally friendly and meet strict state and local air quality emission standards. Some models are even eligible for rebates from the state and are certified for use in environmentally sensitive areas. Low emission pool heaters are composite end covers and a solvent weld connector for easy installation and maintenance.
The cost of running a pool heater is one of the major factors that make pool heating a luxury, but it’s an expense that you should not skimp on. Gas heaters are more efficient and can heat a pool faster, but they are also more expensive than heat pumps. Heat pumps also draw in ambient air through their coils. However, they lose their efficiency if the ambient air temperature drops below 50 degrees. Therefore, if you’re planning to use a pool heat pump, you need to plan your pool heating system accordingly.
Consider the volume of water it will be heating:
When choosing the size of your pool heat exchanger, the first factor to consider is the volume of water it will be heating. When choosing an exchange unit, the most critical factor is the primary heat source. You must choose the right size to heat the pool water volume quickly and efficiently. Depending on the primary heat source, different models may be required.
The AquaCal SQ120R is a two-in-one heater and chiller combination for swimming pools. Its unique design uses warm air to heat the water and a refrigerant module to cool it. It can be used for in-ground and above-ground pools, and the manufacturer recommends installing a grid flow switch to ensure the correct temperature. The unit requires a Wi-Fi Controller to operate.